Open the setup screen from a Macintosh PC.

Troubleshooting

for HDL-GXW series

Manual Top

Open the setup screen from Macintosh.

This section explains how to open the setup screen of this product from Macintosh.

Start up a Web browser, enter the following IP address, and press the [Enter] key.

http://IP address of this product/

Example when the IP address of this product is [192.168.0.200].

"IP address of this product" when DHCP server is available.
Check the IP address assigned to this product by the DHCP server.

In some cases the DHCP server of your broadband router or other devices may hold a record of the IP address that it has assigned to this product. For further details, refer to the operation manual of the device used as the DHCP server.

"IP address of this product" when DHCP server is unavailable.
Enter the IP address set up for this product.

Forgetting the IP address of this product.

If a Windows computer exists in the network, look up the IP address from the Windows.
[Finding out the IP address set up for this product.]

If only Mac OS computers are used, the IP address cannot be looked up.

After disconnecting the LAN cable from this product, restore the IP address of this product to factory default (192.168.0.200).
See [Setting Factory default].

After restoring the IP address to factory default, reset the IP address of this product from the beginning.
[Determine the IP address of this product]

After a while, the screen shown below will be displayed, click [Setup for Administrator].

	Setup screen is not displayed.
	See [Troubleshooting]

[entry of administrator Password.] screen is displayed.

Click the [OK] button without entering anything.

"The administrator password is wrong." message is displayed.

Solution

Refer to the following.
[Troubleshooting]

Setup screen of this product is displayed.

Top of Page